Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Smart Toggle Switch (Lt. Almond) (14293/ZW4003) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Smart Toggle Switch (Lt. Almond) (14293/ZW4003)from GE. To view other Z-Wave products and manuals from GE follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Smart Toggle Switch (Lt. Almond)
SKU Code
14293/ZW4003
Description
Transform any home into a smart home with the GE Z-Wave In-Wall Smart Toggle Switch. The In-Wall Smart Toggle Switch can easily replaces any standard in-wall switch and remotely controls a light in your home. Your home will be equipped with ultimate flexibility with the Jasco Z-Wave Smart Toggle Switch, capable of being used by itself or with up to four add-on switches. Screw terminal installation provides improved space efficiency when replacing existing switches. The GE Z-Wave In-Wall Smart Toggle Switch is compatible with any Z-Wave certified gateway, providing access to many popular home automation systems. Take control of your home lighting with GE Z-Wave Smart Lighting Controls!
Version #
HW: 255 FW: 5.20 was the version certified
Certification #
ZC10-16115300
Certified
2016-11-01T16:13:48.185656
Z-Wave Version
6.51.06

Security

As a Z-Wave Plus certified product, In-Wall Smart Toggle Switch (Lt. Almond) supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    GE describes In-Wall Smart Toggle Switch (Lt. Almond) as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • Neutral Wire Required
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified
    controller to include a device to the Z-Wave network.
    2. Once the controller is ready to add your device,
    press toggle up and release to include it in the network.

    1. Follow the instructions for your Z-Wave certified
    controller to remove a device from the Z-Wave network.
    2. Once the controller is ready to remove your device,
    press toggle up or down to exclude it from the network.

    Factory reset In-Wall Smart Toggle Switch (Lt. Almond)

    1. Quickly press ON (up) button three (3) times then
    immediately press the OFF (down) button three
    (3) times.
    Note: This should only be used in the event your
    network’s primary controller is missing or otherwise
    inoperable.

    Please note that this is a user manual In-Wall Smart Toggle Switch (Lt. Almond) from GE is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Smart Toggle Switch (Lt. Almond) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.