The following is an overview of the user manual for the Z-Wave product In-Wall Touch Sensing Smart Dimmer (14289/ZW3009)from GE. To view other Z-Wave products and manuals from GE follow that link.
Overview
The GE Z-Wave Touch Sensing Dimmer brings together advanced touch sensing technology with an intuitive, minimalist design that sets a new standard for in-wall smart lighting controls. The sleek GE Z-Wave Touch Dimmer is poised to meet every interior design requirement with interchangeable paddle options
available. Regardless of the home décor, users can complement any design aesthetics with paddle colors available in light almond, black, white, brown, and ivory.
The GE Z-Wave Touch Dimmer also features advanced settings to remember the most recent light levels. For example, the dimmer automatically remembers the last used settings and smoothly returns to the same light level when it is turned back on. This simple one-touch feature allows users to set
the perfect lighting level every time.
Security
As a Z-Wave Plus certified product, In-Wall Touch Sensing Smart Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
Features
GE describes In-Wall Touch Sensing Smart Dimmer as having the following features:
- Switch Load Capacity Watts
- Neutral Wire Required
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Adding your device to a Z-Wave network
1. Follow the instructions for your Z-Wave certified
controller to add a device to the Z-Wave network.
2. Once the controller is ready to add your device, press
and release anywhere on the touch panel.
To remove and reset the device
1. Follow the instructions for your Z-Wave certified controller
to remove a device from the Z-Wave network.
2. Once the controller is ready to remove your device, press
and hold the side button (G) of the smart dimmer. While
holding, press and release anywhere on the touch panel,
then release the side button to remove it from the network.
Factory reset In-Wall Touch Sensing Smart Dimmer
To return your switch to factory defaults
1. Press and release side program button (G) three times quickly. The
LED will flash ON/OFF five (5) times when completed successfully.
All button presses must be completed within five (5) seconds.
Note: This should only be used in the event your network’s
primary controller is missing or otherwise inoperable.
Invert LED
1. Press and hold the side program button (G).
2. Touch and release anywhere on the capacitive touch surface 3 times quickly.
3. Release side button to invert LED.
Please note that this is a user manual In-Wall Touch Sensing Smart Dimmer from GE is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Touch Sensing Smart Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.