Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Plug-in Dual Smart Dimmer, With USB Charging (28175/ZW3106) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Plug-in Dual Smart Dimmer, With USB Charging (28175/ZW3106)from GE. To view other Z-Wave products and manuals from GE follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Plug-in Dual Smart Dimmer, With USB Charging
SKU Code
28175/ZW3106
Description
Transform any home into a smart home with the GE Z-Wave Plug-in Dual Smart Dimmer With 3.4A USB Charging. This module enable wireless control on on/off and dim functions for standard incandescent table and floor lamps, as well as dimmable fluorescent, LED and CFL fixtures and more ! Use the dimming control to customize the lighting output and create the perfect ambiance for any room. The space-saving horizontal module plugs into a standard wall receptacle without blocking the second outlet or obstructing placement of furniture. This module also enables you to have independent or simultaneous control of each outlet! Take control of your home lighting with GE Z-Wave Smart Lighting Controls!
Version #
HW: 255 FW: 5.21 was the version certified
Certification #
ZC10-17045539
Certified
2017-04-05T23:00:53.746501
Z-Wave Version
6.51.08

Security

As a Z-Wave Plus certified product, Plug-in Dual Smart Dimmer, With USB Charging supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    GE describes Plug-in Dual Smart Dimmer, With USB Charging as having the following features:

    • Firmware updatable via a compatible Z-Wave gateway
    • Loads Controlled
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-wave certified controller to
    add the device to the Z-wave network.
    2. Once the controller is ready to add your smart switch,
    single press and release the manual/program button on the
    smart switch to add it in the network.
    3. Once your controller has confirmed that the smart switch
    has been added, refresh the Z-wave network to optimize
    performance.

    1. Follow the instructions for your Z-wave certified controller to
    remove a device from the Z-wave network.
    2. Once the controller is ready to remove your device, press and
    release the manual/program button on the smart switch to
    remove it from the network.

    Factory reset Plug-in Dual Smart Dimmer, With USB Charging

    1. If plugged in, unplug the Switch from the receptacle.
    2. Press and hold the top button for at least 3 seconds while you
    plug the switch into a receptacle.
    Note: This should only be used in the event your network’s
    primary controller is missing or otherwise inoperable.

    Please note that this is a user manual Plug-in Dual Smart Dimmer, With USB Charging from GE is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Plug-in Dual Smart Dimmer, With USB Charging and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.