Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Portable Smart Multi Sensor (35211/ZW6302B) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Portable Smart Multi Sensor (35211/ZW6302B)from GE. To view other Z-Wave products and manuals from GE follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Portable Smart Multi Sensor
SKU Code
35211/ZW6302B
Description
Make the move toward convenience with the Z-Wave Portable Smart Motion Sensor for your home. This Z-Wave compatible device boosts the safety and intelligence of your home by working with your home’s gateway to wirelessly trigger scenes and send alerts to your smartphone or tablet whenever motion, light or temperature change is detected. The discreet, versatile design of the sensor makes it suitable for any indoor space, with a detection range up to 180 degrees and up to 45 feet away. Depending on your room size, the sensor also offers three different motion-detecting sensitivity levels: low, medium and high. The sensor sits perfectly on a shelf, table, counter or desk, and can also be mounted to wall or ceiling by using the included mounting hardware. This sensor can be powered with the included batteries (up to two years of battery life) or via Micro USB cable (sold separately). Smart controls require a standalone Z-Wave remote or supported Z-Wave hub, including SmartThings, Wink, Staples Connect, Harmony Home, Piper, ADT Pulse, Vera, and Nexia. This product guaranteed with a 2-year limited warranty.

Version #
HW: 255 FW: 5.21 was the version certified
Certification #
ZC10-17015409
Certified
2017-01-29T21:13:20.172226
Z-Wave Version
6.51.07

Security

As a Z-Wave Plus certified product, Portable Smart Multi Sensor supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    GE describes Portable Smart Multi Sensor as having the following features:

    • Battery Quantity
    • Battery powered using CR123 batteries
    • Firmware updatable via a compatible Z-Wave gateway
    • Sensors
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset Portable Smart Multi Sensor

    1. Press the button 10 times within 6 seconds
    (interval between 2 presses of the button
    cannot be longer than 1 second).
    2. The blue LED will blink for 3 seconds.

    1. Follow the instructions for your Z-Wave certified
    controller to add the device in the Z-Wave network.
    2. Once the controller is ready to add your
    motion sensor, press and release the button
    on the sensor to add it in the network.
    3. The blue LED will activate for 3 seconds to
    confirm it has been included in the network.

    1. Follow the instructions for your Z-Wave certified controller
    to remove the device from the Z-Wave network.
    2. Once the controller is ready to remove your
    motion sensor, press and release the button on
    the sensor to exclude it from the network.
    3. The LED will blink for 3 seconds at a time.

    NOTE: If the sensor’s power source is changed
    after initial setup (ex: USB power instead of
    battery power), the sensor must be excluded
    from the network and then re-included.

    Please note that this is a user manual Portable Smart Multi Sensor from GE is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Portable Smart Multi Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.