The following is an overview of the user manual for the Z-Wave product One X5100 (S30851-S2563-R101)from Gigaset. To view other Z-Wave products and manuals from Gigaset follow that link.
Overview
Security
As a Z-Wave Plus certified product, One X5100 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
Gigaset describes One X5100 as having the following features:
- Controller Supports Multiple Networks
- Z-Wave Scene Type
- Color
- Communications Connections
- Firmware updatable via a compatible Z-Wave gateway
- Gateway Has Preferred Partners
- IP (Ingress Protection) Rated
- Supported Notification Types
- Controller Supports Multiple Z-Wave Interfaces
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
- Enter the Z-Wave Portal
- Choose MORE, then MAINTANACE and then REMOVE DEVICE
- Now start the removing procedure of your Z-Wave device according to its manual
To remove node from your Z-Wave network, you need to start your browser and log in to the web interface of the controller (Z-Ware Portal). Then click on "MORE", "MAINTANANCE" and "REMOVE DEVICE". Then start the exclusion procedure on the node according to it's manual.
Factory reset One X5100
- Enter the Z-Wave Portal
- Tab on MORE, then MAINTANACE and then RESET
- Confirm Reset by choosing CONFIRM and after couple of seconds the Reset is finished
N/A
- Enter the Z-Wave Portal
- From the menu choose DEVICES and then + ADD DEVICE
- Now start the inclusion procedure of your Z-Wave device according to its manual
To add new node (e.g. sensor) to your Z-Wave network, you need to start your browser and log in to the web interface of the controller (Z-Ware Portal). Then click on "DEVICES" and click on "+ ADD DEVICE". Then start the inclusion procedure on the node according to it's manual.
There's also other place in Z-Ware Portal where you can add a new node - "MORE" / "MAINTANANCE" and the click on "ADD DEVICE".
You can start the learn mode by assesing the web interface (Z-Wave Portal) and after logging in click on "MORE", "MAINTANANCE" and "SET LEARN MODE".
SmartStart location
SmartStart QR code's location as follows: If your Gigaset ONE X5100 has no sensors added (e.g. it has been just reset to factory settings)
you can set the LEARN MODE and read DSK (Device Specific Key).
To do that:
- Enter the Z-Wave Portal
- From the menu choose MORE and MAINTANANCE and select SET LEARN MODE
The LEARN MODE is active, the DSK will be displayed in the popup after couple of seconds.
The product is not limited strictly to Smart Home solutions, but also includes CAT iq based telephony functionalities from Gigaset. This makes it possible to connect Gigaset's Universal Handsets to the Gigaset ONE X5100 in addition to registering smart home devices.
Please note that this is a user manual One X5100 from Gigaset is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have One X5100 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.