The following is an overview of the user manual for the Z-Wave product Gd00z-4 (GD00Z-4)from GoControl. To view other Z-Wave products and manuals from GoControl follow that link.
Overview
Security
As a Z-Wave Plus certified product, Gd00z-4 supports Z-Wave S2 security. The following security modes are directly supported:
Features
GoControl describes Gd00z-4 as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Gd00z-4
Press and release the button in the side of the unit 5 times within 10 seconds only when the primary controller is not available.
With the hub in ""Add"" mode, press the release the button on the side of the GD00Z.
With the hub in ""Remove"" mode, press the release the button on the side of the GD00Z.
Please note that this is a user manual Gd00z-4 from GoControl is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Gd00z-4 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.