The following is an overview of the user manual for the Z-Wave product Wd500z5-1 (WD500Z5-1)from GoControl. To view other Z-Wave products and manuals from GoControl follow that link.
Overview
Security
As a Z-Wave Plus certified product, Wd500z5-1 supports Z-Wave S2 security. The following security modes are directly supported:
Features
GoControl describes Wd500z5-1 as having the following features:
- Color
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Neutral Wire Required
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Removing from a Network:
1. Set the Controller into Removal Mode and follow its instruction to delete the GoControl Dimmer from the Controller.
2. Remove the switch by tapping the paddle 2 times. The LED will begin blinking slowly for 10 seconds indicating that it has been removed.
3. You should see an indication on your Controller that the “device was removed” from the network.
Factory reset Wd500z5-1
To Reset Unit (If Required):
Use only in the event that your primary Controller is lost or otherwise inoperable, to reset the GoControl Dimmer and clear all network information, follow these steps:
1. Tap the top of the switch five (5) times.
2. Press and hold the bottom of the switch for 15 seconds. The LED will increasingly blink faster to indicate that a Reset is taking place.
Adding to a Network:
1. With your Controller in Discovery or Add Mode, tap the switch. The LED will blink slowly when in ADD Mode.
2. You should see an indication on your Controller that the “device was added” to the network and the LED will stop blinking.
3. The device will appear in the list of Switches. It should display as a switch.
Please note that this is a user manual Wd500z5-1 from GoControl is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Wd500z5-1 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.