The following is an overview of the user manual for the Z-Wave product WI15VZ-1 Smart Irrigation Controller (WI15VZ-1)from GoControl. To view other Z-Wave products and manuals from GoControl follow that link.
Overview
Integrated diagnostics and flow sensor support help determine breaks or improper operation of the irrigation system.
Security
As a Z-Wave Plus certified product, WI15VZ-1 Smart Irrigation Controller supports Z-Wave S2 security. The following security modes are directly supported:
Features
GoControl describes WI15VZ-1 Smart Irrigation Controller as having the following features:
- Color
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset WI15VZ-1 Smart Irrigation Controller
In the event that your Hub is lost or otherwise inoperable, to reset the GoControl Irrigation Controller and clear all network information, follow these steps:
1. Tap the button five (5) times.
2. Then press and hold the button for 15 seconds. The Status LED will
increasingly blink faster to indicate that a Reset is taking place.
When the WI15VZ-1 is first powered up, the Status LED should be Red. If the Status LED is Green, the WI15VZ-1 needs to be reset (see below). To add it to your network refer to your controller operating instructions.
1. With your controller in Discovery or Add Mode, tap the button (See Figure8).
2. You should see an indication on your controller that the “device was added” to the network and the Green LED will blink. The device will appear in the list of switches. It should display as a switch. If the controller shows the addition failed, repeat Steps 1-3.
The GoControl Irrigation Controller can be removed from the network by the controller. Refer to the controller operating instructions for details.
1. Set the controller into Removal Mode and follow its instructions to delete it from the controller.
2. Remove the Irrigation Controller by tapping the button 2 times.
3. You should see an indication on your controller that the “device was
removed” from the network and the Green LED will blink then turn Red.
Please note that this is a user manual WI15VZ-1 Smart Irrigation Controller from GoControl is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have WI15VZ-1 Smart Irrigation Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.