Ws15z5-1 (WS15Z5-1) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Ws15z5-1 (WS15Z5-1)from GoControl. To view other Z-Wave products and manuals from GoControl follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
WS15Z5-1
SKU Code
WS15Z5-1
Description
The WS15Z5-1 is a Smart in-wall switch designed providing the ideal mood for every situation for the entire home. Not only can this switch control the connected load, with Central Scene support it can run up to 8 scenes created by the Hub, making the familiar light switch the most versatile Home Automation light switch available. It can essentially control lights and devices throughout the entire home. With Over The Air upgrading supported, this device can be seamlessly updated to the most recent firmware and software features. Finally, as a Z-Wave plus product, it’s 30% longer range is ideal for easily creating a strong Z-Wave mesh network for an easier installation and more reliable operation.
Version #
HW: 255 FW: 1.26 was the version certified
Certification #
ZC10-17045537
Certified
2016-12-14T03:18:30.919565
Z-Wave Version
6.51.09

Security

As a Z-Wave Plus certified product, Ws15z5-1 supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    GoControl describes Ws15z5-1 as having the following features:

    • Color
    • Electric Load Type
    • Switch Load Capacity Volt-Ampere
    • Neutral Wire Required
    • Z-Wave Scene Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset Ws15z5-1

    To reset the WS15Z5-1 and clear all network information, follow these steps:
    1. Tap the top of the switch fi ve (5) times.
    2. Press and hold the bottom of the switch for 15 seconds. The LED will increasingly blink faster to indicate that a Reset is taking place.

    With your Controller in Discovery or Add Mode, tap the switch. The LED will blink slowly when in ADD Mode.

    You should see an indication on your Controller that the “device was added” to
    the network and the LED will stop blinking.

    The device will appear in the list of Switches. It should display as a switch.

    Set the Controller into Removal Mode and follow its instruction to delete the
    WS15Z5-1 from the Controller.

    Remove the switch by tapping the paddle 2 times. The LED will begin blinking
    slowly for 10 seconds indicating that it has been removed.

    You should see an indication on your Controller that the “device was removed”
    from the network.

    Please note that this is a user manual Ws15z5-1 from GoControl is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Ws15z5-1 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.