The following is an overview of the user manual for the Z-Wave product Wt00z5-1 (WT00Z5-1)from GoControl. To view other Z-Wave products and manuals from GoControl follow that link.
Overview
Security
As a Z-Wave Plus certified product, Wt00z5-1 supports Z-Wave S2 security. The following security modes are directly supported:
Features
GoControl describes Wt00z5-1 as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Neutral Wire Required
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Wt00z5-1
To Reset Unit (If Required):
In the event that your primary Controller is lost or otherwise inoperable, to reset
the WT00Z5-1 and clear all network information, follow these steps:
1. Tap the top of the switch fi ve (5) times.
2. Press and hold the bottom of the switch for 15 seconds. The LED will
increasingly blink faster to indicate that a Reset is taking place.
Adding to a network:
Refer to your Controller operating instructions to add this switch under the
command of the Wireless Controller.
1. With your Controller in Discovery or Add Mode, tap the switch. The LED will
blink slowly when in ADD Mode.
2. You should see an indication on your Controller that the “device was added”
to the network and the LED will stop blinking.
3. The device will appear in the list of Switches. It should display as a switch.
If the Controller/Gateway shows the addition failed, repeat Steps 1-3.
Removing from a network:
The WT00Z5-1 can be removed from the network by the Controller/Gateway.
Refer to the Controller operating instructions for details.
1. Set the Controller into Removal Mode and follow its instruction to delete the
WT00Z5-1 from the Controller.
2. Remove the switch by tapping the paddle 2 times. The LED will begin
blinking slowly for 10 seconds indicating that it has been removed.
3. You should see an indication on your Controller that the “device was
removed” from the network.
Please note that this is a user manual Wt00z5-1 from GoControl is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Wt00z5-1 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.