The following is an overview of the user manual for the Z-Wave product Z-Wave Garage Door Controller (GD00Z-7)from GoControl. To view other Z-Wave products and manuals from GoControl follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-Wave Garage Door Controller supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
GoControl describes Z-Wave Garage Door Controller as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Supported Notification Types
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Place your Z-Wave Controller into Exclude mode.
2. Press and release the link button on the GD00Z-7.
1. Place your Z-Wave Controller into Discovery or Include mode.
2. Press and release the link button on the GD00Z-7.
Factory reset Z-Wave Garage Door Controller
Reset the GD00Z-7 by pressing the LINK button 5 times. A quick beep followed by a longer beep will indicate the reset.
Reset should only be used in the case of a missing or inoperative primary controller.
Please note that this is a user manual Z-Wave Garage Door Controller from GoControl is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave Garage Door Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.