Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Outdoor Strobe Siren (GS-ZSS08) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Outdoor Strobe Siren (GS-ZSS08)from Golden Security. To view other Z-Wave products and manuals from Golden Security follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Outdoor Strobe Siren
SKU Code
GS-ZSS08
Description
This product can be included and operated in any Z-Wave™ network with other Z-Wave™ certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network. The siren support 110dB alarm sound and light flashing to threaten burglars/intruders.
Version #
HW: 19 FW: 1.32 was the version certified
Certification #
ZC10-18015964
Certified
2018-01-18T21:06:53.387072
Z-Wave Version
6.71.01

Security

As a Z-Wave Plus certified product, Outdoor Strobe Siren supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Golden Security describes Outdoor Strobe Siren as having the following features:

  • Battery Quantity
  • Switch Load Capacity Current
  • Switch Load Capacity Volt-Ampere
  • Switch Load Capacity Watts
  • Outdoor Use
  • Battery powered using 18560 batteries
  • Supported Notification Types
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

1、 Set Z-Wave™ Controller into exclusion mode
2、 Power on the device.
3、 Press the button 3 times within 1.5s
4、 The device will be entered into exclusion mode automatically.

1、 Set Z-Wave™ Controller into inclusion mode,
2、 Power on the device.
3、 Press the button 3 times within 1.5s.
4、 The device will be entered into inclusion mode automatically.

Factory reset Outdoor Strobe Siren

Note: please use the reset procedure only when the primary controller is missing or inoperable.
Operation as below:
1、 Power on the device.
2、 Keep holding touched the button for 10s until the led turn to red, then release.

Please note that this is a user manual Outdoor Strobe Siren from Golden Security is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Outdoor Strobe Siren and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.