Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

PIR Motion Sensor (GS-ZWMS08) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product PIR Motion Sensor (GS-ZWMS08)from Golden Security. To view other Z-Wave products and manuals from Golden Security follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
PIR Motion Sensor
SKU Code
GS-ZWMS08
Description
This product can be included and operated in any Z-Wave™ network with other Z-Wave™ certified devices from other manufacturers and/or other applications. All non-battery operated nodes within the network will act as repeaters regardless of vendor to increase reliability of the network.
Version #
HW: 17 FW: 1.80 was the version certified
Certification #
ZC10-18015965
Certified
2018-01-18T21:07:15.104972
Z-Wave Version
6.71.01

Security

As a Z-Wave Plus certified product, PIR Motion Sensor supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Unauthenticated

Features

Golden Security describes PIR Motion Sensor as having the following features:

  • Switch Load Capacity Watts
  • Switch Load Capacity Current
  • Color
  • Battery Quantity
  • Supported Notification Types
  • Battery powered using CR123A batteries
  • Switch Load Capacity Volt-Ampere
  • Sensors
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Press the button briefly, Led will blink once.

1、 Power up the device.
2、 Set Z-Wave™ Controller into inclusion mode
3、 Press the button 3 times within 1.5s to enter inclusion mode.
4、 The device will be recognized and automatically included into Z-Wave™
Network.

1、 Power up the device.
2、 Set Z-Wave™ Controller into exclusion mode
3、 Press the button 3 times within 1.5s to enter exclusion mode

Factory reset PIR Motion Sensor

Note : please use the reset procedure only when the primary controller is missing or inoperable.
Operation:
1、 Power up the device.
2、 Press and hold the button for 10s until led lights is on, then release the
button.

Please note that this is a user manual PIR Motion Sensor from Golden Security is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have PIR Motion Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.