The following is an overview of the user manual for the Z-Wave product Door/Window Sensor (TS2001)from Good Way Technology, Co., Ltd. To view other Z-Wave products and manuals from Good Way Technology follow that link.
Overview
Security
As a Z-Wave Plus certified product, Door/Window Sensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Good Way Technology describes Door/Window Sensor as having the following features:
- Battery powered using 3.6V 1/2AA ER14250 batteries
- Sensors
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
The Z-Wave Window/Door Sensor stays in sleep status for the majority of time in order to conserve battery power. However, it can be woken up at specified intervals by setting WAKE_UP_INTERVAL_SET command.
To manually include the device, press Tamper three times repeatedly to perform the actions.
LED Status:Blue LED solid light
To manually exclude the device, press Tamper three times repeatedly to perform the actions.
LED Status:Blue LED 1 sec. flashes 3 times
Factory reset Door/Window Sensor
The Device Reset Locally Notification Command is used to advertise that the device will be reset to default.
In Wake up time, Press tamp key 2 times, then the third long press 5s, then device will clear the data back to the factory default.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Door/Window Sensor from Good Way Technology, Co., Ltd is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Door/Window Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.