In-wall switch (TD13010) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-wall switch (TD13010)from Good Way Technology, Co., Ltd. To view other Z-Wave products and manuals from Good Way Technology follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


In-wall switch
SKU Code
This In-wall Power Monitor Switch is a transceiver which is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network. Mini-sized design makes it easy to place the In-wall Power Monitor Switch into the wall box and fit in the house decoration.
Version #
HW: 1 FW: 2.05 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, In-wall switch supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated


Good Way Technology describes In-wall switch as having the following features:

  • Firmware updatable via a compatible Z-Wave gateway
  • Supported Meter Type
  • Supported Notification Types
  • Switch Type
  • Loads Controlled
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Factory reset In-wall switch

Press the pairing button 3 times in 2 seconds and press and hold the pairing button for more than 5 seconds at the 3rd time.
The module is excluded and restores to factory default setting.
Then the module will be in auto-inclusion mode for 2 minutes.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.

The Device Reset Locally Command Class is used to notify central controllers that a Z-Wave device is resetting its network specific parameters.

Include/Exclude Button - Inclusion/exclusion, press 3 times in 2 seconds

Include/Exclude Button - Inclusion/exclusion, press 3 times in 2 seconds

Please note that this is a user manual In-wall switch from Good Way Technology, Co., Ltd is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have In-wall switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.