Light Dimmer Switch (TD14010) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Light Dimmer Switch (TD14010)from Good Way Technology, Co., Ltd. To view other Z-Wave products and manuals from Good Way Technology follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Light Dimmer Switch
SKU Code
The RGBW Controller uses PWM output signal, which enables it to Control LED,RGB, RGBW strips. Controlled devices may be powered by 12 or 24 VDC.
Version #
HW: 255 FW: 2.01 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Light Dimmer Switch supports Z-Wave S2 security. The following security modes are directly supported:


    Good Way Technology describes Light Dimmer Switch as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    LED Signal:Blinking Green (Interval: 1 sec.)
    Touch three times (Must release in 2 sec.)
    Include the R.G.B.W. Color LED Dimmer into the Z-wave network, press 3 times in 2 seconds. If the device is properly included, the green light will remains on.

    LED Signal:Blinking Green(Interval: 1 sec.)
    Touch three times (Must release in 2 sec.)
    Exclude the R.G.B.W. Color LED Dimmer into the Z-Wave network, press 3 times in 2 seconds. If the device is properly excluded, the green light will blink and the data will be reset to the factory default values.

    Factory reset Light Dimmer Switch

    When the Controller is damaged or lost, and you have already transferred the control function to an external control switch before, the product can be normally operated. In other case, please purchase a new Controller, press the Include/Exclude Button three times to exclude the device, and then include the device with the original installation steps, the device can be restored to normal operation. Please note that re-including the product will reset the data to the default values. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.

    Please note that this is a user manual Light Dimmer Switch from Good Way Technology, Co., Ltd is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have Light Dimmer Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.