Panic Button (TR1B120Z1) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Panic Button (TR1B120Z1)from Good Way Technology, Co., Ltd. To view other Z-Wave products and manuals from Good Way Technology follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Panic Button
SKU Code
The Panic Button is a wireless switch designed to control the Panic or Scene status of other associated devices through the Z-Wave controller. After receiving the signals emitted by the Panic Button, the Z-Wave controller can then give commands or operate according to its own settings. Its great compatibility with Z-Wave products makes it suitable for smart home cloud based gateway.
Version #
HW: 1 FW: 1.00 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Panic Button supports Z-Wave S2 security. The following security modes are directly supported:

  • S2 Authenticated
  • S2 Unauthenticated


Good Way Technology describes Panic Button as having the following features:

  • Supported Notification Types
  • Battery Quantity
  • Battery powered using AAA batteries
  • Firmware updatable via a compatible Z-Wave gateway
  • FLiRS capable
  • Supports Network Wide Inclusion
  • Supports Z-Wave Explorer Frames
  • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

Installation instructions

Push the button three times in 1.5 seconds.
When inclusion successful, the LED will be RED blink three times.

Push the button three times in 1.5 seconds.
When exclusion successful, the LED will be RED blink three times. And the LED will be red blinking for 30 seconds at one blink per two seconds. The device is now waiting to inclusion.

The Z-Wave Panic Button wakes up by wake up timer or presses the physical button once, it will send Wakeup Notification Command to the node ID that requires to be reported and stay awake for 10 seconds, if no WAKE_UP_NO_MORE_INFORMATION command is received.

Factory reset Panic Button

Push the button three times in 1.5 seconds and hold the third push for 10 seconds till the LED is red blinking. When reset is successful, the device is set to factory default and now waiting to inclusion
Please use this procedure only when the network primary controller is missing or otherwise inoperable.

Please note that this is a user manual Panic Button from Good Way Technology, Co., Ltd is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have Panic Button and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.