Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Cellular Shade Radio Z-Wave (CSZ1) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Cellular Shade Radio Z-Wave (CSZ1)from Graber. To view other Z-Wave products and manuals from Graber follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Cellular Shade Radio Z-Wave
SKU Code
CSZ1
Description
Enjoy the comfort, convenience and energy efficiency of beautiful custom motorized window treatments featuring Z-Wave protocol for easy integration. Lighting control has never been more simple. Window treatments can be automated using your favorite Z-Wave certified gateway or security system, or controlled by a remote control. Raise or lower the shades to control just the right amount of light, privacy and solar heat. Shades can be fully open, fully closed or anywhere in between, it’s up to you. In addition, some systems will also report back the state of the battery charge on battery operated versions.
Version #
HW: 255 FW: 187.65:1.09 was the version certified
Certification #
ZC10-16055081
Certified
2016-05-13T14:21:06.8048
Z-Wave Version
6.61.00

Security

As a Z-Wave Plus certified product, Cellular Shade Radio Z-Wave supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Graber describes Cellular Shade Radio Z-Wave as having the following features:

    • Battery powered using AA Lithium batteries
    • Color
    • Firmware updatable via a compatible Z-Wave gateway
    • Switch Load Capacity Current
    • Switch Load Capacity Watts
    • Switch Type
    • Window Covering Control Features
    • Battery Quantity
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Put Primary Controller into
    Inclusion Mode

    2. Press and Hold Shade Programming Button for >2seconds

    1. Put Primary Controller into
    Exclusion Mode

    2. Press and Hold Shade Programming Button for >2seconds

    Factory reset Cellular Shade Radio Z-Wave

    Please use this procedure only when the network primary controller is missing or otherwise inoperable

    Press and hold the button on the shade for approximately 15 seconds (the LED will stop flashing when complete)

    The Wakeup command class should be configured by a hub when the remote is joined to a Z-Wave network. A WAKE_UP_INTERVAL_SET command should configure the NodeID at a minimum. The Wakeup interval can be configured to any value from 6 minutes to 25 hours. Recommendation is to leave the interval at the default of 12 hours to maximize battery life. The remote will wake up every WakeUpInterval and send a WakeUp Notification command as well as a battery report to the NodeID assigned with the Interval Set command. The WakeUp Notification will be sent within a few minutes of power being applied to the remote and then once every Wake Up Interval. A Wakeup Interval Capabilities command will inform the hub of the default, minimum, maximum and step size of the Wake Up interval.

    Please note that this is a user manual Cellular Shade Radio Z-Wave from Graber is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Cellular Shade Radio Z-Wave and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.