The following is an overview of the user manual for the Z-Wave product Roller Shade Radio Z-Wave (RSZ1)from Graber. To view other Z-Wave products and manuals from Graber follow that link.
Overview
Security
As a Z-Wave Plus certified product, Roller Shade Radio Z-Wave supports Z-Wave S2 security. The following security modes are directly supported:
Features
Graber describes Roller Shade Radio Z-Wave as having the following features:
- Window Covering Control Features
- Battery Quantity
- Battery powered using AA Lithium batteries
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put Primary Controller into
Inclusion Mode
2. Press and Hold Shade Programming Button for >2seconds
1. Put Primary Controller into
Exclusion Mode
2. Press and Hold Shade Programming Button for >2seconds
Factory reset Roller Shade Radio Z-Wave
Press and hold the button on the shade for approximately 15 seconds (the LED will stop flashing when complete).
""Please use this procedure only when the network primary controller is missing or otherwise inoperable.""
The Wakeup command class should be configured by a hub when the remote is joined to a Z-Wave network. A WAKE_UP_INTERVAL_SET command should configure the NodeID at a minimum. The Wakeup interval can be configured to any value from 6 minutes to 25 hours. Recommendation is to leave the interval at the default of 12 hours to maximize battery life. The remote will wake up every WakeUpInterval and send a WakeUp Notification command as well as a battery report to the NodeID assigned with the Interval Set command. The WakeUp Notification will be sent within a few minutes of power being applied to the remote and then once every Wake Up Interval. A Wakeup Interval Capabilities command will inform the hub of the default, minimum, maximum and step size of the Wake Up interval.
Please note that this is a user manual Roller Shade Radio Z-Wave from Graber is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Roller Shade Radio Z-Wave and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.