The following is an overview of the user manual for the Z-Wave product Gkt-1000a (GKT-1000A)from GUARDTEC. To view other Z-Wave products and manuals from GUARDTEC follow that link.
Overview
A security enabled Z-Wave Controller must be use. The GKT-1000A supports the standard security S0 and the new security standard S2.
Security
As a Z-Wave Plus certified product, Gkt-1000a supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
Features
GUARDTEC describes Gkt-1000a as having the following features:
- Supported Notification Types
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Communications Connections
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Gkt-1000a
* Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
1. Press the [*] button.
2. Press the Master Pin [1234] button after pressing the [#] button.
3. press the [00] button after pressing the [*] button.
1. Set the controller in inclusion mode.
2. Press the [*] button.
3. Press the Master Pin [1234] button after pressing the [#] button.
4. press the [88] button after pressing the [*] button.
1. Set the controller in exclusion mode.
2. Press the [*] button.
3. Press the Master Pin [1234] button after pressing the [#] button.
4. press the [99] button after pressing the [*] button.
Please note that this is a user manual Gkt-1000a from GUARDTEC is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Gkt-1000a and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.