The following is an overview of the user manual for the Z-Wave product IR Transceiver (HKZW-ACC01)from Hank. To view other Z-Wave products and manuals from Hank follow that link.
Overview
Security
As a Z-Wave Plus certified product, IR Transceiver supports Z-Wave S2 security. The following security modes are directly supported:
Features
Hank describes IR Transceiver as having the following features:
- Color
- Communications Protocol
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset IR Transceiver
Press and hold the Z-button for 20 seconds. IR Transceiver will send “Device_Reset_Locally” to the main controller and exclude from the Z-Wave network, this procedure will reset the Sensor to factory default.
Please include a request to use the reset procedure only when the primary controller is missing or inoperable.
Remove for exclusion;
1. Connect power supply.
2. Set the Z-Wave network main controller into learning mode.
3. Triple clicking the Z- button.
4. If the remove for exclusion is successful, Led will blink fast for less than 5 seconds and keep blinking slowly. Otherwise, led will blink for 5 seconds and then keep on , in which case you need to repeat the process from step 2.
Add for inclusion (non-security):
1. Connect power supply.
2. Set the Z-Wave network main controller into learning mode.
3. Triple clicking the Z- button.
4. If the add for inclusion is successful, the LED will blink fast for less than 5 seconds and then keep on. Otherwise, the LED will blink 5 seconds and then keep blinking slowly, in which case you need to repeat the process from step 2.
Add for inclusion (security):
1. Connect power supply.
2. Set the Z-Wave network main controller into learning mode.
3. Press and hold the Z-button for 3 seconds.
If the add for inclusion is successful, the LED will blink for less than 5 seconds and then keep on. Otherwise, the LED will blink 5 seconds and then keep blinking slowly, in which case you need to repeat the process from step 2.
Please note that this is a user manual IR Transceiver from Hank is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have IR Transceiver and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.