The following is an overview of the user manual for the Z-Wave product Multisensor (HKZW-MS01)from Hank. To view other Z-Wave products and manuals from Hank follow that link.
Overview
Security
As a Z-Wave Plus certified product, Multisensor supports Z-Wave S2 security. The following security modes are directly supported:
Features
Hank describes Multisensor as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Battery powered using CR123A batteries
- Sensors
- Supported Notification Types
- Battery Quantity
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Multisensor
Press and hold the Z-button for 20 seconds,
Multisensor will send “Device_Reset_Locally” to the main controller and exclude from the Z-Wave network when the Z-Button is released, this procedure will reset the Sensor to factory default.
Please include a request to use the reset procedure only when the primary controller is missing or inoperable.
Remove for exclusion;
1. Insert two CR123A batteries.
2. Set the Z-Wave network main controller into removing mode (see Z-Wave controller operating manual).
3. Triple clicking the Z-button.
4. If the removing is successful, the LED will blink slowly for 5 seconds and then turn off, otherwise you need to repeat the process from step 2.
2. Add for inclusion (non-security):
1) Insert two CR123A batteries.
2) Set the Z-Wave network main controller into learning mode (see Z-Wave network controller operating manual).
3) Triple clicking the Z-button.
4) If the inclusion is successful, the LED will blink less than 5 seconds and then keep on for 3 seconds, otherwise the LED will blink 5 seconds and then turn off, in which you need to repeat the process from step 2.
Add for inclusion (security):
1) Insert two CR123A batteries.
2) Set the Z-Wave network main controller into learning mode (see Z-Wave network controller operating manual).
3) Press and hold the Z-button for 3 seconds.
4) If the inclusion is successful, the LED will blink fast for less than 5 seconds and then keep on for 3 seconds, otherwise the LED will blink fast for 5 seconds and then turn off, in which you need to repeat the process from step 2.
Please note that this is a user manual Multisensor from Hank is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Multisensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.