The following is an overview of the user manual for the Z-Wave product Smart Plug (HKZW-SO01)from Hank. To view other Z-Wave products and manuals from Hank follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Plug supports Z-Wave S2 security. The following security modes are directly supported:
Features
Hank describes Smart Plug as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Set the Z-Wave network main controller into learning mode. Short press the Z-button, the LED will keep turning on or off, which indicates the inclusion is successful.
Set the Z-Wave network main controller into remove mode. Triple click the Z-button, the LED will blink slowly, which indicates the inclusion is successful.
Factory reset Smart Plug
Press and hold the Z-button for more than 20 seconds, the LED will blink faster and faster when the button is pressed. If holding time more than 20seconds, the LED indicator will be on for 3 seconds then it blinking slowly, which indicates the reseting is successful. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Smart Plug from Hank is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Plug and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.