The following is an overview of the user manual for the Z-Wave product Smart Switch (HKZW-SW01)from Hank. To view other Z-Wave products and manuals from Hank follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Switch supports Z-Wave S2 security. The following security modes are directly supported:
Features
Hank describes Smart Switch as having the following features:
- Color
- Electric Load Type
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Neutral Wire Required
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1) Connect the power supply.
2) Set the Z-Wave network main controller into learning mode (see Z-Wave network controller operating manual).
3) Triple click the Z-Button, LED indicator should blink fast。
4) Smart Switch should be recognized and included into the Z-Wave network.
1) Connect the power supply.
2) Set the Z-Wave network controller into the remove mode (see Z-Wave controller operating manual)
3) Triple click the Z-button.
Factory reset Smart Switch
1) Power on the Switch.
2) Press and hold the Z-button for more than 20 seconds.
3) If holding time more than one second, the LED will blink faster and faster. If holding time more than 20 seconds, the LED indicator will be on for 3 seconds, which indicates that the reset is complete, then it will blink slowly indicating that it is not a part of a Z-Wave network.
Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Smart Switch from Hank is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.