The following is an overview of the user manual for the Z-Wave product Smart Switch (HKZW-SW02)from Hank. To view other Z-Wave products and manuals from Hank follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Switch supports Z-Wave S2 security. The following security modes are directly supported:
Features
Hank describes Smart Switch as having the following features:
- Color
- Switch Load Capacity Current
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Electric Load Type
- Supported Meter Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Add for inclusion(non-security)
1. Set the Z-Wave network main controller into learning mode.
2. Power up smart switch.
3. RGB LED will blink in blue for less than 5 seconds, and then keep on for 3 seconds to indicate that the add for
inclusion is successful. RGB LED will be in power indication mode after it is included into Z-Wave network.
Add for inclusion(security):
1. Set the Z-Wave network main controller into learning mode.
2. Press Z-button for more than 3 seconds.
3. RGB LED will blink in green for less than 5 seconds, and then keep on for 3 seconds to indicate that the add for
inclusion is successful. RGB LED will be in power indication mode after it is included into Z-Wave network.
Remove for exclusion:
1. Set the Z-Wave network main controller into removing mode.
2. Short press Z-button thrice (within 1 second).
3. RGB LED will blink in orange for less than 5 seconds, and then keep on for 3 seconds to indicate that the remove
for exclusion is successful. RGB LED will be in power indication mode after it is removed from Z-Wave network.
Factory reset Smart Switch
Press and hold for more than 20 seconds. RGB LED will keep on for 3 seconds in yellow and Smart switch will send Device_Reset_Locally” to the main controller and exclude from the Z-Wave network, this procedure will reset Smart switch to factory default.
Please use this reset procedure only when the primary controller is missing or inoperable.
Please note that this is a user manual Smart Switch from Hank is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.