The following is an overview of the user manual for the Z-Wave product Z-wave Static Controller (HKZW-STICK)from Hank. To view other Z-Wave products and manuals from Hank follow that link.
Overview
Security
As a Z-Wave Plus certified product, Z-wave Static Controller supports Z-Wave S2 security. The following security modes are directly supported:
Features
Hank describes Z-wave Static Controller as having the following features:
- Communications Connections
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
It is a hardware product, the inclusion depends on the software like PC Controller.
It is a hardware product, the exclusion depends on the software like PC Controller.
It is a hardware product, the learn mode depends on the software like PC Controller.
Factory reset Z-wave Static Controller
Can only reset by software. Plug the stick to the PC’s USB port, start PC Controller and then it can add or remove other Z-Wave device.
Please note that this is a user manual Z-wave Static Controller from Hank is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-wave Static Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.