The following is an overview of the user manual for the Z-Wave product Z-han (Z-HAN)from Heatit. To view other Z-Wave products and manuals from Heatit follow that link.
Overview
Heatit Z-HAN is equipped with an RJ45 port for connection to the AMS meter. The Heatit Z-HAN can be powered through the RJ45 port by most AMS meters, but it also has a 5V micro USB port for external power supply.
Security
As a Z-Wave Plus certified product, Z-han supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Heatit describes Z-han as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: Paragraph 9.
The QR-Code is needed when including a device using S2 security or SmartStart. The DSK can be found in the QR-Code and is located;
• On the product.
• On the Quick Guide.
• On the gift box.
The primary controller/gateway has a mode for adding devices. Please refer to your primary controller manual on how to set the primary controller in add mode. The device may only be added in the network if the primary controller is in add mode.
We recommend adding the device within a 2m range from the gateway.
Method 1: Standard (Manual)
Add mode is indicated on the device by a blinking green LED. It indicates this for 90 seconds until a timeout occurs, or until the module has been added to/removed from the network.
To start the configuration process, press the reset button 3 times in rapid succession. The LED will light up in green for 3 seconds if adding is successful. The device is now ready for use with default settings.
The primary controller/gateway has a mode for removing devices. Please refer to your primary controller manual on how to set the primary controller in remove mode. The device may only be removed from the network if the primary controller is in remove mode. When the device is removed from the network, it will NOT revert to factory settings.
We recommend removing the device within a 2m range from the gateway.
Standard (Manual)
Remove mode is indicated on the device by a blinking green LED. It indicates this for 90 seconds until a timeout occurs, or until the module has been removed from the network.
To start the configuration process, press the reset button 3 times in rapid succession. The LED will light up in green for 3 seconds if removing is successful. The device is now ready for use with default settings.
Factory reset Z-han
Press and hold the reset button. After 3 seconds the LED will start to blink in green. After 20 seconds the LED will shine solid green for 3 seconds. You may now release the button.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
The device connects to your Smart AMS meter through the HAN port and reports your home electricity consumption to your Z-Wave compatible smart home.
Please note that this is a user manual Z-han from Heatit is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-han and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.