The following is an overview of the user manual for the Z-Wave product Z-Temp2 (Z-Temp2)from Heatit controls. To view other Z-Wave products and manuals from Heatit follow that link.
Overview
with water based heating systems. Used in combination with the
Heatit Z-Water regulator you can control your heating system with a
Z-Wave primary controller/gateway with the use of Heatit Z-Water in
combination with one or several Heatit Z-Temp2.
Security
As a Z-Wave Plus certified product, Z-Temp2 supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Heatit describes Z-Temp2 as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- Color
- Battery Quantity
- Battery powered using AA 1,5V Alkaline batteries
- Thermostat HVAC Systems Supported
- Thermostat Power Source
- Thermostat Modes
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The QR Code is needed when including using S2-Security or SmartStart. The Z-Wave DSK can be found in the QR-Code and is located;
1. On the back of wall mount (above the battery compartment).
2. Inside the packaging attached on the note.
3. On the product packaging.
Remove.
Please refer to your primary controller/gateway manual on how to enter remove mode. The device can only be removed from the network if the primary controller is in remove mode.
When the primary controller/gateway is set to remove modus press the link button on the thermostat 3 times in a rapid sequence.
The thermostat is a FLIRS device. You are able to force a Node Information Frame using the same procedure as adding/removing procedure; "press the link button on the thermostat 3 times in a rapid sequence."
Paragraph 8. Compability/ Principles for regulation. Water based heating - Electrical heating.
Paragraph 9. Information shown in display. The main screen - Secondary screen - Connecting to an external relay.
Paragraph 10. Hysteresis.
Paragraph 11. Child lock.
Paragraph 12. Standby and main screen.
Factory reset Z-Temp2
By pressing and holding the link button for 20 seconds, the thermostat will perform a complete factory reset.
rES will be displayed.
NB! Please use this procedure only when the primary controller/gateway is missing or otherwise inoperable.
There are two ways to add your devices in a Z-Wave network.
* Standard (manual).
Please refer to your primary controller/gateway manual on how to enter add mode. The device can only be added to the network if the primary controller is in add mode.
When the primary controller/gateway is set to add mode press the link button on the thermostat 3 times in a rapid sequence.
* SmartStart (automatic)
Please refer to your primary controller/gateway to see if SmartStart is supported by the controller. SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR-Code present on the product with a controller providing SmartStart inclusion. No further action is required and the SmartStart product will be added automatically within 10 minutes of being switched on in the network vicinity.
Please note that this is a user manual Z-Temp2 from Heatit controls is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Temp2 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.