The following is an overview of the user manual for the Z-Wave product Z-TRM2fx (Z-TRM2fx)from Heatit controls. To view other Z-Wave products and manuals from Heatit follow that link.
Overview
The thermostat has the capacity of up to 8 associations (relays, wall plugs etc.).
The thermostat is designed for electrical heating.
FEATURES
Floor sensor
External room sensor
Temperature limiter
Weekly program/setback via gateway or pilot wire
Multilevel sensor command class
Firmware updates (OTA)
Power metering
LED-diode
Can be used in connection with different NTC-sensors
Lock mode/child lock
Calibration
8 associations
Supports encryption mode: S0, S2 Authenticated Class, S2 Unauthenticated Class
Security
As a Z-Wave Plus certified product, Z-TRM2fx supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Heatit describes Z-TRM2fx as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Neutral Wire Required
- Sensors
- Thermostat HVAC Systems Supported
- Thermostat Modes
- Thermostat Power Source
- Supported Meter Type
- Supported Notification Types
- Color
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Removing the device:
To remove the thermostat to your home automation gateway, press Center (confirm) for 10 seconds. The display will show OFF. Press Right (down) 4 times till you see Con in the display. Now start remove device in your home automation software. Start removing mode by pressing Center (confirm) button for approximately 2 seconds. The icon will appear in the display. Removing Mode is indicated in the display by some “circling” LED segments in the display until the timeout occurs after 20 seconds or the module has been removed in the network. Confirmation will show Inc/EcL in the display. If removing fails, Err (error) will appear.
Adding the device:
To add the thermostat to your home automation gateway, press Center (confirm) for 10 seconds. The display will show OFF. Press Right (down) 4 times till you see Con in the display. Now start add device in your home automation software. Start adding mode by pressing Center (confirm) button for approximately 2 seconds. The icon will appear in the display. Adding Mode is indicated in the display by some “circling” LED segments in the display until the timeout occurs after 20 seconds or the module has been added in the network. Confirmation will show Inc/EcL in the display. If adding fails, Err (error) will appear.
Factory reset Z-TRM2fx
By pressing buttons Right and Center (down and confirm) for 20 seconds, the thermostat will perform a complete factory reset.
NB! Please use this procedure only when the primary controller/ gateway is missing or otherwise inoperable.
Please note that this is a user manual Z-TRM2fx from Heatit controls is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-TRM2fx and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.