The following is an overview of the user manual for the Z-Wave product ZM Thermostat 16A (ZM Thermostat 16A)from Heatit controls. To view other Z-Wave products and manuals from Heatit follow that link.
Overview
The thermostat allows you to control your electrical heating through your Z-Wave™ network. The module is equipped with a 16A single pole relay. The thermostat requires you to connect an external sensor which is included with the device.
The device can withstand a max load of 16A at 230VAC.
Security
As a Z-Wave Plus certified product, ZM Thermostat 16A supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Heatit describes ZM Thermostat 16A as having the following features:
- Firmware updatable via a compatible Z-Wave gateway
- IP (Ingress Protection) Rated
- Neutral Wire Required
- Outdoor Use
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Thermostat HVAC Systems Supported
- Thermostat Modes
- Thermostat Power Source
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset ZM Thermostat 16A
Press and hold the configuration button. After 3 seconds the LED will start to blink in green. After 20 seconds the LED will start to blink green rapidly for 5 seconds. You may now release the button
The primary controller/gateway has a mode for removing devices. Please refer to your primary controller manual on how to set the primary controller in remove mode. The device may only be removed from the network if the primary controller is in remove mode.
Remove mode is indicated on the device by a blinking green LED. It indicated this for 90 seconds until a timeout occurs, or until the module has been removed from the network. To start the configuration process, press the configuration button 3 times in rapid succession. The LED will light up green for 3 seconds if removing is successful.
Paragraph 11.1 Overload.
Paragraph 11.2 Overheating.
SmartStart location
SmartStart QR code's location as follows: The QR-Code is needed when including a device using S2 security or SmartStart. The DSK can be found in the QR-Code and is located;
1. On the product.
2. On the Quick Guide manual.
3. On the F-Pack (gift box).
The primary controller/gateway has a mode for adding devices. Please refer to your primary controller manual on how to set the primary controller in add mode. The device may only be added to the network if the primary controller is in add mode.
There are two ways to add the device to a Z-Wave network.
Method 1: Standard (Manual)
Add mode is indicated on the device by a blinking green LED. It indicated this for 90 seconds until a timeout occurs, or until the module has been added to the network. To start the configuration process, press the configuration button 3 times in rapid succession. The LED will light up green for 3 seconds if adding is successful.
The device is now ready for use with default settings.
Method 2: SmartStart (Automatic)
SmartStart enabled products may be added to a Z-Wave network by scanning the Z-Wave QR-Code on the product if your primary controller supports SmartStart inclusion. No further action is required and the SmartStart product will be added automatically after being powered on within range of the primary controller.
Please note that this is a user manual ZM Thermostat 16A from Heatit controls is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have ZM Thermostat 16A and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.