Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Smart Smoke Sensor (HS1SA-Z) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Smart Smoke Sensor (HS1SA-Z)from HEIMAN. To view other Z-Wave products and manuals from HEIMAN follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Smart Smoke Sensor
SKU Code
HS1SA-Z
Description
The smart smoke sensor detects smoke, and sends an alarm signals to alert of danger. When the smart smoke sensor detects smoke, it will send an alarm notification to your gateway through wireless Z-Wave communication protocol. Then the gateway will send the notification to the server, the server interprets the signal and transfers the signal to users' APP. The smart smoke sensor has high stability and sensitivity, which will alert house of fire effectively.
Version #
HW: 255 FW: 1.10 was the version certified
Certification #
ZC10-16095242
Certified
2016-09-28T09:27:37.8572
Z-Wave Version
6.51.08

Security

As a Z-Wave Plus certified product, Smart Smoke Sensor supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    HEIMAN describes Smart Smoke Sensor as having the following features:

    • Battery Quantity
    • Battery powered using CR123A batteries
    • Color
    • Communications Connections
    • Communications Protocol
    • Firmware updatable via a compatible Z-Wave gateway
    • IP (Ingress Protection) Rated
    • Switch Load Capacity Current
    • Switch Load Capacity Volt-Ampere
    • Switch Load Capacity Watts
    • Outdoor Use
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    - Click [Add] icon in Z-Wave PC Controller Program.
    - Press the Net_Button 3 times within 1.5s, Green LED is Blinking 3 times within 1 second.
    - If Inclusion Process is successful, Green led will turn off.

    - Click [Remove] icon in Z-Wave PC Controller Program
    - Press the Net_Button 3 times within 1.5s
    - If Exclusion Process is successful, Green led is Blinking 6 times, then turn off.

    Factory reset Smart Smoke Sensor

    -Long press Net_Button while installing batteries in HS1SA-Z.
    - Device Reset Locally notification is Transmitted.
    -Please use this procedure only when the network primary controller is missing or otherwise inoperable.

    - Wake up Notification is transmitted every 24 hours by default.
    - Wake up Notification is transmitted after Notification Report is Transmitted

    Please note that this is a user manual Smart Smoke Sensor from HEIMAN is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Smoke Sensor and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.