The following is an overview of the user manual for the Z-Wave product Smart Switch (HS2SW1A-Z)from HEIMAN. To view other Z-Wave products and manuals from HEIMAN follow that link.
Overview
Security
As a Z-Wave Plus certified product, Smart Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
HEIMAN describes Smart Switch as having the following features:
- Electric Load Type
- Switch Load Capacity Volt-Ampere
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Watts
- Color
- Switch Type
- Communications Protocol
- Supported Notification Types
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
‐ Click [Remove] icon in Z‐Wave Controller.
‐ Press the Net_Button 3 times within 1.5s.
-If remove Process is successful, Green LED will flash 6 times, then turn off.
‐ Click [Add] icon in Z‐Wave Controller.
- Press the Net_Button 3 times within 1.5s, Green LED will flash 3 times within 1 .5s.
‐ If add Process is successful, Green LED will turn off.
Factory reset Smart Switch
‐Long press Net_Button at least 10 seconds in the product.
‐ Device Reset Locally notification is Transmitted.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual Smart Switch from HEIMAN is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Smart Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.