The following is an overview of the user manual for the Z-Wave product Touch Panel Switch (HE-TPS05)from HELTUN. To view other Z-Wave products and manuals from Heltun follow that link.
Overview
Features:
• Five-channel 5-amp relays with dry contact inputs
• Five programmable touch buttons with two-color backlights
• All buttons fully customizable to control one to five relays
• Five modes configurable for each button
• Each relay may be controlled by a timer or on a week schedule
• Separate relays & backlights control from gateway or associated devices
• Controls Scenes of gateway by touch buttons (pressed, held, released)
• Built-in light, temperature, and humidity sensors
• Power Consumption logic monitors energy usage
• 20 association groups
• Incorporates HELTUN Advanced Zero-Cross Technology
• ‘Impossibly thin’ at only 9mm
The HELTUN HE-TPS05 is part of an entire line of smart, connected products designed to provide the best technology has to offer without compromising stylish living.
Security
As a Z-Wave Plus certified product, Touch Panel Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
Heltun describes Touch Panel Switch as having the following features:
- Z-Wave Scene Type
- Switch Load Capacity Current
- Switch Type
- Neutral Wire Required
- Firmware updatable via a compatible Z-Wave gateway
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart location
SmartStart QR code's location as follows: The device DSK and QR code are printed on the HE-TPS05 back panel plus on the additional Security Card included in the HE- TPS05 packaging.
To add the HE-TPS05 to a Z-Wave Network (i.e. “inclusion”), do the following:
1. Start the inclusion mode from the gateway/controller.
2. To start the inclusion process on the HE-TPS05, simultaneously press the two bottom touch buttons and hold them for three seconds.
3. The two upper buttons will then sequentially blink ‘blue-red’.
4. If the inclusion has been successful, the two upper buttons will turn blue for three seconds.
5. If the inclusion was not successful, the two upper buttons will turn red for three seconds. In that case repeat the inclusion process.
To remove the HE-TPS05 from a Z-Wave Network (i.e. “exclusion”), do the following:
1. Start the exclusion mode from the gateway/controller.
2. To start the exclusion process on the HE-TPS05, simultaneously press the two bottom touch buttons and hold them for three seconds.
3. Two upper buttons will sequentially blink blue-red.
4. If the exclusion has been successful, the two upper buttons will turn red for three seconds.
5. If the exclusion was not successful, the two upper buttons will turn blue for three seconds. In that case repeat the exclusion process.
Factory reset Touch Panel Switch
To reset the HE-TPS05 to factory defaults, simultaneously press the two bottom buttons and single central touch button, and hold all three for five seconds. If successful, the two upper buttons will turn blue for three seconds then the device will restart.
NOTE: This factory reset procedure will change all parameters to the original factory default values and will also exclude the device from any associated Z-Wave network.
Please use Factory Reset only when the primary network controller is missing or otherwise inoperable.
Please note that this is a user manual Touch Panel Switch from HELTUN is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Touch Panel Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.