The following is an overview of the user manual for the Z-Wave product 1 Touch Panel Dimmer (HTP-1SD)from Hogar Controls. To view other Z-Wave products and manuals from Hogar Controls follow that link.
Overview
Featuring a stunning glass face with an advanced capacitive touch sensor, all you need to do is just use a finger for full dimming control and for turning your lights on and off. Tap the back-lit touch button on the panel to switch on or off, and long-press the same button to smoothly dim the lights. This 1 Touch Panel Dimmer ensures that the brightness intensity set is achieved without any loss.
The Hogar 1 Touch Panel Dimmer can operate either independently or as a part of the Hogar smart home automation system, and even with any other certified Z-Wave home automation system. It is an extremely easy-to-use panel that installs in a standard BS 2 gang box. Its operating capabilities include a bi-stable mode, a relay mode or touch pulse mode for scene control with a maximum load current of 8 amp. It communicates with the Hogar smart home automation system using the Z-Wave wireless communication protocol.
Security
As a Z-Wave Plus certified product, 1 Touch Panel Dimmer supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Hogar Controls describes 1 Touch Panel Dimmer as having the following features:
- Switch Load Capacity Current
- Firmware updatable via a compatible Z-Wave gateway
- Electric Load Type
- Neutral Wire Required
- Switch Load Capacity Watts
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put the controller into INCLUSION mode. Follow the instructions provided by the controller manufacturer.
2. Touch and hold at the centre of touch area for more than 5 seconds. Indication LEDs blinks blue. At this point release the key, the touch dimmer switch start inclusion process.
1. Put the controller into EXCLUSION mode. Follow the instructions provided by the controller manufacturer.
2. Touch and hold at the centre of touch area for more than 5 seconds. Indication LEDs blinks blue. At this point release the key, the touch dimmer switch start exclusion
process.
Factory reset 1 Touch Panel Dimmer
1. Press the config button 5 time, Indication LEDs lights will blinks red in color, touch dimmer switch will start local reset. Touch dimmer switch will erase network inclusion state after local reset.
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
Please note that this is a user manual 1 Touch Panel Dimmer from Hogar Controls is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 1 Touch Panel Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.