The following is an overview of the user manual for the Z-Wave product 1 Touch Panel Switch (HTP-1S0)from Hogar Controls. To view other Z-Wave products and manuals from Hogar Controls follow that link.
Overview
With a stunning glass face and an advanced capacitive touch sensor, all you need to do is just use a finger for turning your lights on and off. Tap once on the backlit touch button to switch the device on and tap it again to turn it off, it’s that simple. This 1 Touch Switch ensures an accurate response to every command that is sent through it.
The Hogar 1 Touch Switch can operate either independently or as a part of the Hogar smart home automation system, and even with any other certified Z-Wave home automation system. It is an extremely easy-to-use panel that can be installed in a standard BS 2 gang box. Its operating capabilities include a bi-stable mode, a relay mode or a touch pulse mode for scene control with a maximum load current of 8 amp. It communicates with the Hogar smart home automation system using the Z-Wave wireless communication protocol.
Security
As a Z-Wave Plus certified product, 1 Touch Panel Switch supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Hogar Controls describes 1 Touch Panel Switch as having the following features:
- Switch Load Capacity Current
- Switch Load Capacity Watts
- Firmware updatable via a compatible Z-Wave gateway
- Electric Load Type
- Neutral Wire Required
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put the controller into ADD device mode. Follow the instructions provided by the controller manufacturer.
2. Touch and hold any key on the panel for more than 5 seconds. All indication lights will blink in blue. At this point release the key, the touch panel will start the inclusion process.
1. Put the controller into REMOVE device mode. Follow the instructions provided by the controller manufacturer.
2. Touch and hold any key on the panel for more than 5 seconds. All indication lights will blink blue in color. At this point release the key, the touch panel will start the exclusion process.
Factory reset 1 Touch Panel Switch
1. Press the config button 5 times, Indication LED lights will blink red in color, touch panel will start local reset.
Touch panel switch will erase network inclusion state after local reset. Please use this procedure only when the network primary controller is missing or otherwise inoperable
Please note that this is a user manual 1 Touch Panel Switch from Hogar Controls is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have 1 Touch Panel Switch and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.