The following is an overview of the user manual for the Z-Wave product Hogar Pebble (HC-TB-ZW)from Hogar Controls. To view other Z-Wave products and manuals from Hogar Controls follow that link.
Overview
It is a compact, battery-powered, Z-wave Plus compatible device that allows you to control various devices through the Z-wave network. As it is based on Z-Wave communication technology, the device can be controlled remotely from anywhere using the internet.
When paired with the HC Pro, our smart home controller, the Pebble lets you design, set and activate up to 9 personalized scenes with different gestures like touch, tap, double tap, press, press and hold, swipe left, swipe right, swipe up, swipe down, swipe clockwise, swipe anticlockwise.
Set the ambiance for date night, wake up to your own personal mix of actions, or have the house locked and secured before you go to bed. Imagine your home at your fingertips because, with Pebble, it is just a matter of touch-and-go.
Security
As a Z-Wave Plus certified product, Hogar Pebble supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Unauthenticated
Features
Hogar Controls describes Hogar Pebble as having the following features:
- Battery Quantity
- Battery powered using CR3032 batteries
- Firmware updatable via a compatible Z-Wave gateway
- Z-Wave Scene Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Put the controller into INCLUSION mode. Follow the instructions
provided by the controller manufacturer.
2. Press and hold the config button for more than 2 seconds. ALL indicator lights will blink 3 times. At this point release the config button, the device will start the inclusion process.
1. Put the controller into EXCLUSION mode. Follow the instructions provided by the controller manufacturer.
2. Press and hold the config button for more than 2 seconds. ALL indicator lights will blink. At this point release the config
button, the device will start the exclusion process.
1) Touch the center of the touch area, all indicator LEDs will blink ON then OFF, after all LEDs are OFF, the device will wake up.
2) Then touch on the touch area 3 times, the device will send Wakeup Notification.
Factory reset Hogar Pebble
Please use this procedure only when the network primary controller is missing or otherwise inoperable.
To reset the device, use stick press and hold Config button till all LEDs are ON (about 5 seconds). The device is successfully removed from the network and reset.
Please note that this is a user manual Hogar Pebble from Hogar Controls is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Hogar Pebble and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.