The following is an overview of the user manual for the Z-Wave product Hub (H4P-WC)from HomeIQ. To view other Z-Wave products and manuals from HomeIQ follow that link.
Overview
Security
As a Z-Wave Plus certified product, Hub supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Access Control
- S2 Authenticated
- S2 Unauthenticated
Features
HomeIQ describes Hub as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
SmartStart installation
Add to Provisioning List
1. The SmartStart-Add command will prompt for the DSK of the device to be added
Factory reset Hub
Using the console application you can execute the “Network-Reset” command to factory reset the Z-Wave controller.
Please note that this is a user manual Hub from HomeIQ is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Hub and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.