The following is an overview of the user manual for the Z-Wave product Base (NA930)from Homelive. To view other Z-Wave products and manuals from Homelive follow that link.
Overview
The Homelive app lets you control all the connected appliances in your home from one place, accessible from your smartphone or tablet. You can even set up custom alerts, tailored to your needs. With Homelive, you can configure your house from your smartphone or tablet to suit your daily routine. You can, for example, arrange for the heating to come on automatically depending on the outside temperature, or program the lights to switch on at dusk.
Security
As a Z-Wave Plus certified product, Base supports Z-Wave S2 security. The following security modes are directly supported:
Features
Homelive describes Base as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
To include a Z-Wave product into the network, you can use the UI and follow the on- screen instructions that read as follows:
Select Add device -> Pick the device to be included in the network from the list -> Follow the steps for inclusion of the device -> Once the device is detected, save the name of the device and the device completes the configuration process. [Attached images along with the manual].
For an installer who wishes to carry out a manual setup of devices, tap the Z-Wave button on the controller. To exit the inclusion mode on the controller, tap the Z-Wave button again.
To exclude a Z-Wave product into the network, you can use the UI and follow the on- screen instructions that read as follows:
Navigate to the device -> Select the delete device option -> Choose to un-pair and follow the instructions. [Attached images along with the manual].
For an installer who wishes to manually exclude a Z-Wave product from the network, hold the Z-Wave button down for 3 seconds.
To include the controller into an existing Z-Wave network, use the UI and follow the steps below.
Click on Settings -> Z-Wave Settings -> Advanced, select 'Copy Z-Wave network from a primary controller. This will shift the controller to have a secondary controller role and will receive data from the primary controller in the network.
Factory reset Base
Please use this procedure only in the event that the system primary controller is missing or otherwise inoperable.
To reset the controller, press the reset button for 20 seconds. This will reset it to factory default.
The controller has a in built sim for internet backup.
Please note that this is a user manual Base from Homelive is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Base and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.