The following is an overview of the user manual for the Z-Wave product HomeTroller S6 (HT-S6)from HomeSeer. To view other Z-Wave products and manuals from HomeSeer follow that link.
Overview
Main Features:
- Controls Light Switches, Thermostats, Door Locks, Garage Doors, Water Valves, Energy Monitors, Environmental Sensors, Cameras and More!
- Runs all HomeSeer Drivers (plug-ins)
- Compatible with Apple and Andoid smartphones and tablets
- Includes voice control and programming features
- Can issue spoken messages for alerts, announcement and reminders
- Available in standard and PRO versions
Security
As a Z-Wave Plus certified product, HomeTroller S6 supports Z-Wave S2 security. The following security modes are directly supported:
Features
HomeSeer describes HomeTroller S6 as having the following features:
- Controller Supports Multiple Z-Wave Interfaces
- Firmware updatable via a compatible Z-Wave gateway
- Z-Wave Scene Type
- Controller Supports Multiple Networks
- Gateway Has Preferred Partners
- Supported Notification Types
- Supported Meter Type
- Sensors
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
From the UI, select the Plugins menu, then the Z-Wave Plugin, then choose the Controller Management option. In the list of actions for the Z-Wave interface, choose ""Add/Include a Node"", and follow the on-screen prompts.
From the UI, select the Plugins menu, then the Z-Wave Plugin, then choose the Controller Management option. In the list of actions for the Z-Wave interface, choose ""Remove/Exclude a Node"", and follow the on-screen prompts.
From the UI, select the Plugins menu, then the Z-Wave Plugin, then choose the Controller Management option. In the list of actions for the Z-Wave interface, choose ""Receive Network from Another Controller"", and follow the on-screen prompts.
Factory reset HomeTroller S6
Please use this procedure only as a last resort as existing nodes in the network will be orphaned and unable to be controlled.
Access the Interfaces page from the UI. Click on the Z-Wave plug-in link on the interfaces page to be taken to the diagnostics page for the plug-in, then press the Factory Reset button at the top of the page.
Please note that this is a user manual HomeTroller S6 from HomeSeer is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have HomeTroller S6 and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.