The following is an overview of the user manual for the Z-Wave product HS-PD100+ Lamp Module (HS-PD100+)from HomeSeer. To view other Z-Wave products and manuals from HomeSeer follow that link.
Overview
Security
As a Z-Wave Plus certified product, HS-PD100+ Lamp Module supports Z-Wave S2 security. The following security modes are directly supported:
Features
HomeSeer describes HS-PD100+ Lamp Module as having the following features:
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
1. Plug the 2-pin AC power plugs of lighting device to the receptacle of HS-PD100+
2. Insert the module's 3-pin plug into an AC outlet of your preferred location. In normal operating mode, the LED on the front panel will be lit.
3. Add(Include) the module into your network by a Z-Wave certified controller.
Normally, the sequence is as follows:
a. Place your network controller into inclusion mode by following the controller manufacturer's instructions
b. When the controller is ready, single click the button on the front of HS-PD100+
c. The controller should indicate that the new device was added successfully.
a. Place your network controller into exclusion mode by following the controller manufacturer's instructions
b. When the controller is ready, single click the button on the front of HS-PD100+
c. The controller should indicate that the device was excluded successfully.
Factory reset HS-PD100+ Lamp Module
Use this procedure only in the event that the network primary controller is lost or otherwise inoperable.
1. Unplug the HS-PD100+ from the AC outlet and also unplug the power plugs of the lighting from the module (if plugged in)
2. Press and hold the button on the HS-PD100+
3. Plug the HS-PD100+ back into the AC outlet with the button pressed
4. After 3 seconds, release the button. If you see the button blink, that means that the HS-PD100+ has been reset successfully
Please note that this is a user manual HS-PD100+ Lamp Module from HomeSeer is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have HS-PD100+ Lamp Module and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.