SmartStick+ (HUSBZ-2) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product SmartStick+ (HUSBZ-2)from HomeSeer. To view other Z-Wave products and manuals from HomeSeer follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


SKU Code
SmartStick+ is a Z-Wave Plus certified USB interface for use with HomeSeer and other Z-Wave certified home automation systems. SmartStick+ supports Network Wide Inclusion (NWI) for easy inclusion of Z-Wave products. SmartStick+ may be used with Z-NETs for a centrally managed, muti-network installation.
Version #
1 was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, SmartStick+ supports Z-Wave S2 security. The following security modes are directly supported:


    HomeSeer describes SmartStick+ as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Controlled by the host device the HUSBZ-2 is connected to.

    Factory reset SmartStick+

    Not applicable.

    Controlled by the host device the HUSBZ-2 is connected to.

    Controlled by the host device the HUSBZ-2 is connected to.

    Please note that this is a user manual SmartStick+ from HomeSeer is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. only warrants and is only able to support products purchased directly from us. If you have SmartStick+ and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.