Z-Wave interface module (700 series) (HS-ZWPB700) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Z-Wave interface module (700 series) (HS-ZWPB700)from HomeSeer. To view other Z-Wave products and manuals from HomeSeer follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions


Z-Wave interface module (700 series)
SKU Code
HS-ZWPB700 is a Z-Wave interface module that’s designed to send and receive wireless Z-Wave commands to and from compatible smart home products in the home. It is to assemble to Raspberry Pi to act as a Z-Wave controller to control the Z-Wave sensors and actuators. This module is designed in Z-Wave 700 series SiP to adopt standard S2 and SmartStart native protocols.
Version #
HW: 0 FW: ERROR was the version certified
Certification #
Z-Wave Version


As a Z-Wave Plus certified product, Z-Wave interface module (700 series) supports Z-Wave S2 security. The following security modes are directly supported:


    HomeSeer describes Z-Wave interface module (700 series) as having the following features:

    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset Z-Wave interface module (700 series)


    Please note that this is a user manual Z-Wave interface module (700 series) from HomeSeer is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave interface module (700 series) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.