The following is an overview of the user manual for the Z-Wave product Z-Wave RGB Fan Controller (HS-FC200+)from HomeSeer. To view other Z-Wave products and manuals from HomeSeer follow that link.
Overview
• Works with 3-speed or 4-speed fans only
• 4 segment LED dim level indicator
• Remotely or manually turns ON or OFF, or fan speed level
• Fits standard wall plates (wall plate not included)
• Works with any certified gateway supporting Z-Wave
Security
As a Z-Wave Plus certified product, Z-Wave RGB Fan Controller supports Z-Wave S2 security. The following security modes are directly supported:
- S2 Authenticated
- S2 Unauthenticated
Features
HomeSeer describes Z-Wave RGB Fan Controller as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Load Capacity Volt-Ampere
- Switch Load Capacity Watts
- Neutral Wire Required
- Outdoor Use
- Switch Type
- Z-Wave Scene Type
- Electric Load Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Inclusion: Add the device into your network by a Z-Wave certified controller. HS-FC200+ supports the latest S2 security offered by Z-Wave certified controllers. If your controller supports S2, please refer to the user guide of the controller for detailed instructions on adding devices to the network. You should be able to add HS-FC200+ into your network using the unique QR code or the DSK 5 digit pin located on the product or packaging. In addition, the device can be added or removed using the following 2-step procedure:
1. Put your Z-Wave controller into Inclusion mode. Consult your controller manual if you're unsure how to do this.
2. Tap the paddle of your new HomeSeer switch to begin the inclusion process. This will take a few moments to complete.
Exclusion: Remove the device from your network by a Z-Wave certified controller. HS-FC200+ supports the latest S2 security offered by Z-Wave certified controllers. If your controller supports S2, please refer to the user guide of the controller for detailed instructions on removing devices from the network. You should be able to remove HS-FC200+ into your network using the unique QR code or the DSK 5 digit pin located on the product or packaging. In addition, the device can be added or removed using the following 2-step procedure:
1. Put your Z-Wave controller into Exclusion mode. Consult your controller manual if you're unsure how to do this.
2. Tap the paddle of your new HomeSeer switch to begin the Exclusion process. This will take a few moments to complete.
Under S2 Security / SmartStart, it is mentioned that the, ""DSK can be found on the front metal yoke of the device.""
Factory reset Z-Wave RGB Fan Controller
To be used only in the event that the network primary controller is lost or otherwise inoperable.
(1) Turn switch on by tapping the top of the paddle once.
(2) Quickly ap top of the paddle 3 times.
(3) Quickly tap bottom of paddle 3 times.
(4) If the LED turns off then on again, switch is reset. If not, repeat manual rest.
Please note that this is a user manual Z-Wave RGB Fan Controller from HomeSeer is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Z-Wave RGB Fan Controller and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.