Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Dimmer (39351 / ZW3005) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Dimmer (39351 / ZW3005)from Honeywell. To view other Z-Wave products and manuals from Honeywell follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Dimmer
SKU Code
39351 / ZW3005
Description
Transform any home into a smart home with the Honeywell In-Wall Dimmer. The In-Wall Dimmer can easily replace any standard in-wall switch and remotely controls a light in your home. Your home will be equipped with ultimate flexibility with the Honeywell Z-Wave Dimmer, capable of being used by itself or with up to four add-on switches. Screw terminal installation provides improved space efficiency when replacing existing switches and the integrated LED indicator light allows you to easily locate the switch in a dark room. The Honeywell Z-Wave In-Wall Dimmer is compatible with any Z-Wave certified gateway, providing access to many popular home automation systems. Take control of your home lighting with Honeywell Z-Wave Smart Controls!

Version #
HW: 255 FW: 5.28 was the version certified
Certification #
ZC10-17125898
Certified
2017-12-08T22:05:10.642591
Z-Wave Version
6.51.08

Security

As a Z-Wave Plus certified product, In-Wall Dimmer supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Honeywell describes In-Wall Dimmer as having the following features:

    • Color
    • Firmware updatable via a compatible Z-Wave gateway
    • Switch Load Capacity Watts
    • Neutral Wire Required
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to
    include a device to the Z-Wave network.
    2. Once the controller is ready to add your device,
    press and release the top or bottom of the wireless smart
    switch (rocker) to add it in the network.
    Please reference the controller’s manual for instructions.

    1. Follow the instructions for your Z-Wave certified controller to
    remove a device from the Z-Wave network.
    2. Once the controller is ready to Exclude your device, press
    and release the top or bottom of the wireless smart dimmer
    (rocker) to remove it from the network.

    Factory reset In-Wall Dimmer

    Quickly press ON (Top) button three (3) times then immediately
    press the OFF (Bottom) button three (3) times. The LED will flash
    ON/OFF 5 times when completed successfully.
    NOTE: This should only be used in the event your network’s
    primary controller is missing or otherwise inoperable.

    Please note that this is a user manual In-Wall Dimmer from Honeywell is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Dimmer and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.