Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Dimmer (Toggle) (39357 / ZW3004) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Dimmer (Toggle) (39357 / ZW3004)from Honeywell. To view other Z-Wave products and manuals from Honeywell follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Dimmer (Toggle)
SKU Code
39357 / ZW3004
Description
Transform any home into a smart home with the Honeywell Z-Wave In-Wall Toggle Dimmer. The dimmer enables wireless control of on/off and dim functions of hard-wired dimmable LED/CFL and incandescent lighting. The dimmer replaces your current light switch, uses your existing wiring, and provides Z-Wave wireless and in-wall control of overhead lighting. Use the dimmer feature to customize the lighting output and create the perfect ambiance for any room. Providing ultimate flexibility, the In-Wall Dimmer allows you to operate the switch by itself or easily integrate the switch three-way or four-way wiring configurations by adding the Honeywell Add-On Switch. Single Pole wiring configuration controls the light from one location. Three-way wiring configuration controls the light from two separate locations. Four-way wiring configuration controls the light from three separate locations. The Honeywell Add-On Switch is required for three-way or four-way installations. Take control of your home lighting with Honeywell Z-Wave Smart Controls!
Version #
HW: 255 FW: 5.25 was the version certified
Certification #
ZC10-17125900
Certified
2017-12-08T22:11:49.382943
Z-Wave Version
6.51.08

Security

As a Z-Wave Plus certified product, In-Wall Dimmer (Toggle) supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Honeywell describes In-Wall Dimmer (Toggle) as having the following features:

    • Color
    • Firmware updatable via a compatible Z-Wave gateway
    • Switch Load Capacity Watts
    • Neutral Wire Required
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Factory reset In-Wall Dimmer (Toggle)

    1. Quickly press ON (up) button (3) times then immediately press the OFF (down) button (3) times.
    Note: This should only be used in the even your network's primary controller is missing or otherwise inoperable.

    1. Follow the instructions for your Z-Wave certified controller to
    include a device to the Z-Wave network.
    2. Once the controller is ready to include your device, press
    and release the top or bottom of the wireless smart dimmer
    (rocker) to include it in the network.

    1. Follow the instructions for your Z-Wave certified controller to
    exclude a device from the Z-Wave network.
    2. Once the controller is ready to Exclude your device, press
    and release the top or bottom of the wireless smart dimmer
    (rocker) to exclude it from the network.

    Please note that this is a user manual In-Wall Dimmer (Toggle) from Honeywell is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Dimmer (Toggle) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.