Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Switch (Toggle) (39354 / ZW4003) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Switch (Toggle) (39354 / ZW4003)from Honeywell. To view other Z-Wave products and manuals from Honeywell follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Switch (Toggle)
SKU Code
39354 / ZW4003
Description
Transform any home into a smart home with the Honeywell Z-Wave Toggle Switch. The In-Wall Toggle Switch can easily replaces any standard in-wall switch and remotely controls a light in your home. Your home will be equipped with ultimate flexibility with the Honeywell Z-Wave Toggle Switch, capable of being used by itself or with up to four add-on switches. Screw terminal installation provides improved space efficiency when replacing existing switches and the integrated LED indicator light allows you to easily locate the switch in a dark room. The Honeywell Z-Wave In-Wall Toggle Switch is compatible with any Z-Wave certified gateway, providing access to many popular home automation systems. Take control of your home lighting with Honeywell Z-Wave Smart Controls!
Version #
HW: 255 FW: 5.21 was the version certified
Certification #
ZC10-17125899
Certified
2017-12-08T22:10:51.259317
Z-Wave Version
6.51.10

Security

As a Z-Wave Plus certified product, In-Wall Switch (Toggle) supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Honeywell describes In-Wall Switch (Toggle) as having the following features:

    • Color
    • Firmware updatable via a compatible Z-Wave gateway
    • Switch Load Capacity Current
    • Switch Load Capacity Watts
    • Neutral Wire Required
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.
    2. Once the controller is ready to include your device, press up and release on the toggle to include it in the network.
    3. Once your controller has confirmed that the device has been included, refresh the Z-Wave network to optimize performance.

    1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.
    2. Once the controller is ready to exclude your device, press up and release on the toggle to exclude it from the network.

    Factory reset In-Wall Switch (Toggle)

    1. Quickly press ON (up) 3 times then immediately press the OFF (Down) button 3 times. Note: This should only be used in the event your networks primary controller is missing or otherwise inoperable.

    Please note that this is a user manual In-Wall Switch (Toggle) from Honeywell is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Switch (Toggle) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.