Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

In-Wall Tamper Resistant Outlet (39349 / ZW1002) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product In-Wall Tamper Resistant Outlet (39349 / ZW1002)from Honeywell. To view other Z-Wave products and manuals from Honeywell follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
In-Wall Tamper Resistant Outlet
SKU Code
39349 / ZW1002
Description
Transform any home into a smart home with the Honeywell Z-Wave Tamper Resistant Outlet. The Honeywell Z-Wave Tamper Resistant Outlet enables wireless control of on/off functions from the Z-Wave controlled outlet, and is compatible with incandescent, LED, Xenon, Halogen, fluorescent and compact fluorescent bulbs. The tamper resistant duplex receptacle includes a blue LED indicator light to easily locate the receptacle in a dark room. The receptacle replaces your current electrical outlet, uses your existing wiring and provides a Z-Wave enabled outlet for the lamp or appliance that you would like to control and a standard pass-through AC outlet for other electrical appliances. Take control of your home lighting with Honeywell Z-Wave Smart Controls!
Version #
HW: 255 FW: 5.25 was the version certified
Certification #
ZC10-17115838
Certified
2017-11-09T18:51:16.89411
Z-Wave Version
6.51.09

Security

As a Z-Wave Plus certified product, In-Wall Tamper Resistant Outlet supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Honeywell describes In-Wall Tamper Resistant Outlet as having the following features:

    • Color
    • Firmware updatable via a compatible Z-Wave gateway
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to
    remove a device from the Z-Wave network.
    2. Once the controller is ready to remove your device, press and
    release the manual/program button to remove it from the
    network.

    Follow the instructions for your Z-Wave certified
    controller to add a device to the Z-Wave network.
    2. Once the controller is ready to add your device, press and
    release the Program Button to add it in the network.

    Factory reset In-Wall Tamper Resistant Outlet

    Press the button 3 times, then press and hold the button for at least 3
    seconds. The LED will blink 5 times to confirm.
    NOTE: This should only be used in the event your network’s primary
    controller is missing or otherwise inoperable

    Please note that this is a user manual In-Wall Tamper Resistant Outlet from Honeywell is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have In-Wall Tamper Resistant Outlet and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.