Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Plug-in Dimmer (Dual Plug Simultaneous Control) (39446 / ZW3107) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Plug-in Dimmer (Dual Plug Simultaneous Control) (39446 / ZW3107)from Honeywell Home (Resideo). To view other Z-Wave products and manuals from Honeywell follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Plug-in Dimmer (Dual Plug Simultaneous Control)
SKU Code
39446 / ZW3107
Description
Transform any home into a smart home with the Honeywell Z-Wave Smart Lighting Control Lamp Module with Dimmer Control. The lamp module enables wireless control of on/off and dim functions for standard incandescent table and floor lamps, as well as dimmable fluorescent, LED and CFL fixtures and more! Use the dimmer control to customize the lighting output and create the perfect ambiance for any room. The space-saving horizontal module plugs into a standard wall receptacle without blocking the second outlet or obstructing placement of furniture. It provides a Z-Wave enabled outlet for the lamp you would like to control and one always-on, simultaneous control AC outlet for other electrical appliances. Take control of your home lighting with Honeywell Z-Wave Smart Controls!
Version #
HW: 255 FW: 5.21 was the version certified
Certification #
ZC10-20036897
Certified
2020-03-24T16:53:25.02546
Z-Wave Version
6.51.08

Security

As a Z-Wave Plus certified product, Plug-in Dimmer (Dual Plug Simultaneous Control) supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Honeywell describes Plug-in Dimmer (Dual Plug Simultaneous Control) as having the following features:

    • Switch Type
    • Switch Load Capacity Watts
    • Firmware updatable via a compatible Z-Wave gateway
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    Follow the instructions for your Z-Wave certified controller to remove a device from the Z-Wave network. Once the controller is ready to remove your device, press and release the manual/program button on the smart dimmer to remove it from the network.

    Follow the instructions for your Z-Wave certified controller to add a device to the Z-Wave network. Once the controller is ready to add your device, press and release the manual/program button on the smart dimmer. Repeat as necessary to add the dimmer to the network.

    Factory reset Plug-in Dimmer (Dual Plug Simultaneous Control)

    If plugged in, unplug the dimmer from the receptacle. Press and hold the top button, plug the device in and continue to hold for at least 3 seconds.

    Please note that this is a user manual Plug-in Dimmer (Dual Plug Simultaneous Control) from Honeywell Home (Resideo) is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Plug-in Dimmer (Dual Plug Simultaneous Control) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.