Categories

Aeotec

Atrim

SmartThings

Z-Wave Products

Plug-in Smart Dimmer (Dual Plug With Simultaneous Control) (39339 / ZW3107) manual for Z-Wave

The following is an overview of the user manual for the Z-Wave product Plug-in Smart Dimmer (Dual Plug With Simultaneous Control) (39339 / ZW3107)from Honeywell. To view other Z-Wave products and manuals from Honeywell follow that link.

  1. Overview
  2. Security
  3. Features
  4. Installation instructions

Overview

Name
Plug-in Smart Dimmer (Dual Plug With Simultaneous Control)
SKU Code
39339 / ZW3107
Description
Transform any home into a smart home with the Honeywell Z-Wave Plug-In Dimmer. The Dimmer enables wireless control of on/off and dim functions for standard incandescent table and floor lamps, as well as dimmable fluorescent, LED and CFL fixtures and more! Use the dimmer control to customize the lighting output and create the perfect ambiance for any room. The space-saving horizontal module plugs into a standard wall receptacle without blocking the second outlet or obstructing placement of furniture. The Dimmer provides two Z-Wave enabled outlets for lamps you would like to control. Take control of your home lighting with Honeywell Z-Wave Smart Controls!
Version #
HW: 255 FW: 5.21 was the version certified
Certification #
ZC10-17125901
Certified
2017-12-08T22:49:56.312046
Z-Wave Version
6.51.08

Security

As a Z-Wave Plus certified product, Plug-in Smart Dimmer (Dual Plug With Simultaneous Control) supports Z-Wave S2 security. The following security modes are directly supported:

    Features

    Honeywell describes Plug-in Smart Dimmer (Dual Plug With Simultaneous Control) as having the following features:

    • Color
    • Firmware updatable via a compatible Z-Wave gateway
    • Switch Load Capacity Watts
    • Switch Type
    • FLiRS capable
    • Supports Network Wide Inclusion
    • Supports Z-Wave Explorer Frames
    • Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via

    Installation instructions

    1. Follow the instructions for your Z-Wave certified controller to add
    the smart dimmer to the Z-Wave network.
    2. Once the controller is ready to add your smart dimmer, single
    press and release the manual/program button on the smart
    dimmer to add it in the network.
    Please reference the controller/gateway’s manual for instructions.

    1. Follow the instructions for your Z-Wave certified controller to
    remove a device from the Z-Wave network.
    2. Once the controller is ready to remove your device, press and
    release the manual/program button on the smart dimmer to
    remove it from the network.

    Factory reset Plug-in Smart Dimmer (Dual Plug With Simultaneous Control)

    To return your dimmer to factory defaults:
    1. If plugged in, unplug the dimmer from the receptacle.
    2. Press and hold the top button for at least 3 seconds while you
    plug the dimmer into a receptacle.
    Note: This should only be used in the event your networks’ primary
    controller is missing or otherwise inoperable.

    Please note that this is a user manual Plug-in Smart Dimmer (Dual Plug With Simultaneous Control) from Honeywell is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Plug-in Smart Dimmer (Dual Plug With Simultaneous Control) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.