The following is an overview of the user manual for the Z-Wave product Plug-in Smart Dimmer (Dual Plug With Simultaneous Control) (39446 / ZW3107)from Honeywell. To view other Z-Wave products and manuals from Honeywell follow that link.
Overview
Security
As a Z-Wave Plus certified product, Plug-in Smart Dimmer (Dual Plug With Simultaneous Control) supports Z-Wave S2 security. The following security modes are directly supported:
Features
Honeywell describes Plug-in Smart Dimmer (Dual Plug With Simultaneous Control) as having the following features:
- Color
- Firmware updatable via a compatible Z-Wave gateway
- Switch Load Capacity Current
- Switch Type
- FLiRS capable
- Supports Network Wide Inclusion
- Supports Z-Wave Explorer Frames
- Supports Z-Wave SmartStart allowing you to setup the product simply by scanning its QR code via
Installation instructions
Factory reset Plug-in Smart Dimmer (Dual Plug With Simultaneous Control)
To return your dimmer to factory defaults:
1. If plugged in, unplug the dimmer from the receptacle.
2. Press and hold the top button for at least 3 seconds while you
plug the dimmer into a receptacle.
Note: This should only be used in the event your networks’ primary
controller is missing or otherwise inoperable.
1. Follow the instructions for your Z-Wave certified controller to
remove a device from the Z-Wave network.
2. Once the controller is ready to remove your device, press and
release the manual/program button on the smart dimmer to
remove it from the network.
1. Follow the instructions for your Z-Wave certified controller to add
the smart dimmer to the Z-Wave network.
2. Once the controller is ready to add your smart dimmer, single
press and release the manual/program button on the smart
dimmer to add it in the network.
Please reference the controller/gateway’s manual for instructions.
Please note that this is a user manual Plug-in Smart Dimmer (Dual Plug With Simultaneous Control) from Honeywell is provided as is and without warranty; all information contained herein is provided by the manufacturer or the certifying body. The information provided is for reference only and is not intended to be used as a substitute for professional advice. ZWaveProducts.com only warrants and is only able to support products purchased directly from us. If you have Plug-in Smart Dimmer (Dual Plug With Simultaneous Control) and have not purchased it from us, please contact the manufacturer directly with any further questions you may have.